Beisler 1265-4 - Manual (Page 43)

Service Instructions Automatic Single-Head Serging Machine 1265-4 Beisler GmbH
C-7
C.3.4 Power supply
The machine is connected to a power supply system of 230 V ± 10 % at
50/60 Hz.
WARNING - Electric shock!
Contact with current-carrying components may cause a le-
thal electric shock. Check plug and cable before connec-
ting machine to power supply system.
• Do not use damaged plugs, sockets or cables to con-
nect the machine to the power supply system!
• Before connecting the machine to the power supply sy-
stem, check to see if the ratings of the power supply
system in the operating room correspond with the ra-
tings on the nameplate at the rear of the machine.
• If the ratings for voltage (V) and maximum current (A)
do not match, the machine must not be connected.
• Insert the grounding plug into a properly grounded and
fused power socket.
• Make sure that the power supply cable is not subjected
to tensile or pressure forces.
• Route the power supply cable in a way that ensures
free access to and around the machine.
NOTE - Works to the electrical system
Works to the electrical system of the machine must only
be carried out by qualified and authorized expert person-
nel. Tampering with the machine without authorization will
make the warranty void.
C.3
Start-up