Beisler 1265-4 - Manual (Page 62)

Service Instructions Automatic Single-Head Serging Machine 1265-4 Beisler GmbH
C-26
C.6
Troubleshooting
Error message Cause Correction
Photocells not bright: 13;
15; 16 Photocell does not respond to light
change
Adjust photocell properly; reflective
surface dull, clean as necessary;
replace photocell
I/O communication error
Error during data transmission between
control and I/O module
Check all cable connections (flat ribbon
cables) to 9020013 /. 9020024; if
required, replace contol module 9020013
or module 9020024
ES 02 Photocell 15 missing
Connect photocell 15,
remove link at X24-Pin2
Thread breakage at sewing
head Sewing machine thread monitor has
responded
Pass thread through needle
Error 45-49:
I/O RES Internal hardware error during data
transmission Replace adapter PCB 9020013 –
9020020