Guntermann & Drunck CATCenter X systems Operation - Manual (Page 75)

Guntermann & Drunck GmbH CATCenter Operating Manual
Page 75
submenu without saving your changes, a notification message to that effect will
be displayed.
5.3.1.4 USB Multimedia Keyboard
Select this menu item to activate multimedia USB support in the CATpro2 USB
dongle. By default, this setting is deactivated (value is set to "no")!
This item is only active and therefore selectable if the following conditions have
been met:
 The selected target must be connected to the CATCenter using a
CATpro2 USB dongle.
 This CATpro2 USB dongle must be active.
 The firmware version of the CATpro2 USB dongle must be greater
than or equal to rev. 1.42. You can obtain this information under
system info (first press the
F12 key, then access the menu item
"System Info"). You will find the revision number of the currently
connected CATpro2 USB dongle in the right hand column of the target
line.
5.3.1.5 IBM RS/6000 support
Activate the support for UNIX servers of IBM’s RS/6000 series (option: yes) if
the target computer is such a server.
Note:
This setting can only be edited with PS/2 versions of the target modules.
5.3.1.6 USB power management
The target modules of the CATpro2-USB series are usually switched on as
soon as the USB controller provides the target module with the required
voltage.
Deactivate the »USB power management« setting (option: no) if no screen
content is being displayed on the monitor of the accessing user module while
the target computer is booting.
Note:
This setting can only be edited with USB versions of the target modules.