Guntermann & Drunck CATCenter X systems Operation - Manual (Page 93)

Guntermann & Drunck GmbH CATCenter Operating Manual
Page 93
5.6.1.3 Screensaver Time
The screen saver set here is generated by the CATCenter and is not
connected in any way to the screen saver of the target.
Since there is normally an indirect connection (via the CATCenter) between the
target and the monitor, you should turn the screen saver on the target off to
make your work easier.
The screen saver of the CATCenter assumes this task; it puts the monitor in
power-down mode.
Use the UP ARROW and/or DOWN ARROW keys on your keyboard to select
the entry SCREENSAVER TIME. The existing entry can be overwritten, or
edited by pressing the
ENTER key.
A time of 1 – 99 minutes is valid. The entry "0" sets the screen saver to "OFF".
Once you are finished editing, press the F2 key. All changes are saved and
you return to the CONSOLE CONFIG submenu.
5.6.1.4 Scancode Set
The scancode is the "language" the keyboard uses to communicate with the
target. The CATCenter works with scancode set 2.
Do not modify this setting unless asked to do so by our service
department.
Place the cursor onto the corresponding entry.
By pressing the
SPACEBAR , you can select between the following
alternatives: 2 or 3
Once you are finished editing, press the
F2 key. All changes are saved and
you return to the CONSOLE CONFIG submenu.
5.6.1.5 OSD Keyboard Layout
Use this to adjust the keyboard layout used by the CATCenter to the actual
layout of the connected keyboard. For example, you should modify this setting
if you notice that Y/Z are switched (U.S. / German keyboard layout).