Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 111)

setup and OperatiOn
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 3-3
Gases ON
Sequence of operation with a Hypertherm CNC
Check 3-phase
power input
Power ON
laser power supply
Is
the stack
light green?
Yes
No
Power ON
EDGE Pro
Key switch in
ON position
E-Stop OFF
Press and release the
start button
On
Off
Check interlocks
Chiller ON,
valves open
Reset system faults
(in the CNC watch window)
Is
the stack
light yellow?
No
Yes
The START push
button indicator light
WARNING
Always use personal protective equipment when working on or around laser equipment. See the
safety section in this manual for more details on safety and protective equipment.
Note: These items are cus-
tomer supplied.
see page 2-17 for
details
Check interlocks
Is
the Laser head
controller displaying a fault?
Yes Reset system
faults
No
Ready to cut