Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 142)

setup and OperatiOn
3-34 Hypertherm Fiber Laser Instruction Manual – 807090 Revision 3
Custom waveform
10 VDC
0 VDC
24 VDC
1600 watts
Up to 100 Hz
Process Power
Corner Power
Corner Power
Enable
Digital Beam
Enable
Laser Output
0 VDC
Pulsing the laser with a custom waveform
The CNC can pulse Process Power from 0 to 10 volts up to 100 Hz. This allows the user to create any waveform
desired for pulsing.
Set Corner Pulsing Enabled to 0 volts = OFF for this mode.
Digital beam enable
0 VDC
24 VDC
Maximum rated power
Pulse rate up to
100 Hz
Process Power
Corner Power
Corner Power
Enable
Digital Beam
Enable
Laser Output
0 VDC
10 VDC = 1000 watts for the HFL010 (1.0 kW laser)
10 VDC = 1500 watts for the HFL015 (1.5 kW laser)
10 VDC = 2000 watts for the HFL020 (2.0 kW laser)
10 VDC = 3000 watts for the HFL030 (3.0 kW laser)