Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 64)

InstallatIon
2-16 HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3
Stack Light installation
1. Open the rear door of the fiber laser supply enclosure and
locate the cardboard box on the bottom left below the power
interconnect panel.
2. Remove the stack light, gasket and mounting hardware from the
cardboard box.
3. Mount the stack light to the top of the enclosure, at the location
shown, using the hardware included.
Stack light mounting location
4. Connect the plug on the end of the yellow cable from the stack
light to the socket located directly above the incoming power
disconnect switch.
Plug
Socket
Stack light color descriptions
Red flashing = Laser is on. All safety precautions must be followed.
Yellow = The laser may come on at any time. All safety precautions must
be followed.
Green = Safe