Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 70)

InstallatIon
2-22 HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3
E Mounting the laser head
Install the laser head mounting bracket
The laser head is shipped with a plastic cap covering the main opening. To protect the optics inside the laser head, the
cap must remain in place unless you are told to remove it.
Briefly remove the plastic cap from the laser head and Install the laser head mounting bracket onto the laser head
using the 3 bolts provided. Immediately cover the hole in the laser head mounting bracket with the plastic cap after the
mounting bracket is installed.
Plastic cap
Laser head
mounting bracket Plastic cap