Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 121)

setup and OperatiOn
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 3-13
Laser head controller screen navigation
Operating parameters
Laser head controller display screen field value
Laser Power Current laser output power in watts
Pulse width modulation (PWM) display option Corner power/duty cycle 0-100%
Gas Selection AIR= compressed air
O
2
= oxygen
N
2
= nitrogen
Output Pressure (Default) Output process gas pressure in PSI
(Option) Output process gas pressure in mPA
Note: Option selection is described on the previous page
System State Beam ON
Beam OFF
Faulted
Service
System Status See Error messages in section 4 of this manual
System warning A gas pressure warning is displayed when the gas
pressure is 20% higher or lower than the setpoint
Information shown on the display is described in the following sections.
typical operating screen
Selection knob
Push to Select
Laser power 1500W O2 12 PSI
Beam ON System OK