Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 131)

setup and OperatiOn
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 3-23
Capacitive height sensor (CHS) calibration
The signal for the capacitive height sensor is linearized by the microprocessor in the laser head controller to produce an
output voltage of 0 VDC to 10 VDC to achieve 0 to 10 mm of nozzle-to-work piece distance.
To calibrate CHS, you must perform two processes; one on the laser head controller and the other on the CNC.
To perform the CHS calibration on the laser head controller:
Continued on the next page
Push to Select
+ =
Configuration
screen
Push to Select
+ =
Calibration
screen
+ =
Calibrate CHS
Position
+ =
Laser head
position
screen 1
Push to Select
Laser power 1500W O2 12 PSI
Beam OFF System OK
LHC Ver: 1.13 LPC Ver: 1.17 P2
<Calibrate>
<Diagnostics>
<Setups>
<Back>
Move Head to 1 mm
Push Rotary Wheel when at position
Calibrate Nozzle Position
Calibrate CHS Position
<Back>
Calibrate Nozzle Position
Calibrate CHS Position
<Back>