Hypertherm HyIntensity Fiber Laser Rev.3 - Manual (Page 127)

setup and OperatiOn
HyIntensity Fiber Laser Instruction Manual – 807090 Revision 3 3-19
Laser head controller setup
The laser head controller must be configured for the appropriate type of communication with the CNC.
Note: The laser beam must be turned OFF on the main display screen (shown below) before starting to configure the
laser head controller.
Continued on the next page
Push to Select
+ =
Configuration
screen
+ =
Setups
selected
Push to Select
+ =
Password
screen 1
Push to Select
+ =
Password
screen 2
+ =
Password set
to 15
LHC Ver: 1.13 LPC Ver: 1.17 P2
<Calibrate>
<Diagnostics>
<Setups>
<Back>
Password 0
<Back>
LHC Ver: 1.13 LPC Ver: 1.17 P2
<Calibrate>
<Diagnostics>
<Setups>
<Back>
Laser power 1500W O2 12 PSI
Beam OFF System OK
Password 0
Press Select to accept new values
Timeout in 5 seconds