K-Patents SeedMaster 2 - Manual (Page 35)

6 START UP AND USE 35
35
Alarms
Input and calculated data are monitored and checked against two configurable limit values (High Limit, Low
Limit) in order to detect, signal (“Alarm” LED) and log alarm excursions in the “Events’ history” during an
ACTIVE strike.
Password
Default and “Escape code” 0000
Seeding parameters
•
Seeding valve open (Ton) time 5 sec
•
Syrup quality (“m”, “b”, “c”) parameters “Typical cane”
•
Type of seeding AUTO ON SUPERSAT.
•
Warning on seeding (supersaturation) 0.9
6.3 Device configuration
Whenever SeedMaster 2 is switched ON, the MAIN DISPLAY will come up. Later on it can be accessed any
time by using the
• ESCAPE
key of SeedMaster 2.
Fig. 6.1 shows one of the MAIN DISPLAY versions from the 3 possible ones. When switched ON, depending
on the history of previous CONFIGURATION and SET UP operations and the present strike status, small
differences in the displayed data can be observed. The figure shows a version valid for an in-active strike
(WS: WAIT FOR START of a new strike). In this case there are no calculations in progress, therefore all data
are set to zero. Already configured syrup purity (LI. PUR.: liquor purity) together with concentration and
temperature data from an already connected refractometer are displayed.
MAIN DISPLAY 1 / 0 . 1
SEED: SUPS. =1 . 1 2 AUT STRT: 0 m WS
SUPS. 0 . 0 0 LI. PUR. 0 . 0 %
DENS. 0 kg/m3 LI. CONC. 0 . 0 %
MA. SOL. 0 . 0 % MO. CONS. 0 . 0
CR. CT. 0 . 0 % TEMP. 0 . 0 C
CONSIST. 0 . 0 % CR. SIZE 0 . 0 0 mm
MENU
Fig. 6.1
CONFIGURATION and SET UP can be initiated from the MAIN DISPLAY by using the MENU soft-key. For
details see Chapter 7.
6.4 Basic key operations
The 18 keys on the face-plate of SeedMaster 2 can be accessed after opening the front door of the
enclosure.
NUMBER (0…9) and SIGN ( - ) KEYS
These are used to enter the selected parameters.
ENTER
Use it to close a data entry operation.