Leprecon XC 350 - Manual (Page 119)

XC Users Manual
Page
119
11911930
11.2 Chase properties
Each XC chase has the following properties than can be set when recording the
chase:
Pattern - specified which chase is being recorded.
Step - shows the last step saved
Rate - the speed of the chase, shown in Beats Per Minute (BPM)
Loop Count – Setting a value for Loop Count will stop the chase after a specific
number of cycles.
Blend - Chases can be set to snap from step to step, or fade from one step to
the next. Setting blend to zero sets the chase to snap, and a blend value of
100% will produce a fluid chase that is constantly fading from one step to the
next.
Title – A name given to a specific Chase pattern.
Delete – used to remove a specific step. Clicking Delete will open a dialog box
that allows selection of any step of the current pattern.