Marantz NR1604 User Manual
Page 128
125
Setting items
Setting details
Levels
Set the volume of the test
tone to be the same when it
is output from each speaker.
Test Tone Start : Output test tone.
• Front L / F. Height L / Center / F. Height R / Front R / Surround R /
Surr. Back R
z
/ Surr. Back L
z
/ Surround L / Subwoofer : A test tone
is output from the selected speaker. While listening to the test tone,
adjust the volume output from the selected speaker.
z When the “Speaker Config.” – “Surr. Back” setting (
) is
set to “1spkr”, “Surr. Back” is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
When “Levels” is adjusted, the adjusted values are set for all the
sound modes.
NOTE
• “Levels” cannot be set for speakers with “Speaker Config.”
• When headphones are connected to the PHONES connector on this
unit, you cannot set “Levels”.
Set Defaults : The “Levels” settings are returned to the default settings.
• Reset : Reset to the defaults.
• Cancel : Do not reset to the defaults.
When you select “Set Defaults” and press
ENTER
, the “Reset all of the channel level
settings to the factory defaults?” prompt is
displayed. Select either “Reset” or “Cancel”,
and press
ENTER
.
Speakers
Setting items
Setting details
Distances
Set distance from listening
position to speakers.
Measure beforehand the
distance from the listening
position to each speaker.
Unit : Set the unit of distance.
• Feet / Meters
Step : Set the minimum variable width of the distance.
• 1ft / 0.1ft
• 0.1m / 0.01m
Set Defaults : The “Distances” settings are returned to the default
settings.
• Reset : Reset to the defaults.
• Cancel : Do not reset to the defaults.
When you select “Set Defaults” and press
ENTER
, the “Resets all of the distance
settings to the factory defaults?” prompt is
displayed. Select either “Reset” or “Cancel”,
and press
ENTER
.
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer /
Surround L / Surround R / Surr. Back L
z
/ Surr. Back R
z
: Select
speaker for distance setting.
z When the “Speaker Config.” – “Surr. Back” setting (
) is
set to “1spkr”, “Surr. Back” is displayed.
• 0.0ft – 60.0ft / 0.00m – 18.00m : Set the distance.
• The speakers that can be selected differ depending on the “Amp Assign”
) settings.
• Default settings :
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer : 12.0
ft (3.60 m)
Surround L / Surround R / Surr. Back L / Surr. Back R : 10.0 ft (3.00 m)
• Set the difference in the distance between the speakers to less than
20.0 ft (6.00 m).
NOTE
“Distances” cannot be set for speakers with “Speaker Config.”
(
) set to “None”.
Basic instructions
Advanced instructions
Information
Advanced instructions
v See overleaf
DVD