Marantz NR1604 - Manual (Page 160)

157
GRemote control unitH
Symptom Cause/Solution Page
The set cannot be
operated with the
remote control unit.
• Batteries are worn out. Replace with new batteries.
• Operate the remote control unit within a distance of about
23 ft/7 m from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the q and
w marks.
• The set’s remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
• The setting of the zone to operate does not match. Press MAIN or
ZONE2 to select the zone to operate.
142
142
142
142
142
23 , 91 , 101
Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed.
Note that when the microprocessor is reset, all the settings are reset to their default values.
X M-DAX
ZONE2 SOURCE
1
Turn off the power using X .
2
Press X while simultaneously pressing M-DAX and ZONE2 SOURCE .
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
Basic instructions
Advanced instructions
Information Information
DVD