Channel select, Set up “channel select””) – Marantz NR1604 User Manual
Page 95
92
Set up speakers
7
Set up “Channel Select”
Use
ui
to select “Channel Select”, and then press
ENTER
.
Channel Select
Subwoofer
Surround Back
Measure
Measure(2spkrs)
Audyssey Setup
Channel Select
Amp Assign
Check Results
Restore...
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
8
Use
ui
to select a channel, and then press
ENTER
.
Front
Select for setting the front speakers to be used. In this
case, go to step 9.
• “Front” can be set when “Assign Mode” is set to
“Front B”.
Subwoofer Select for no subwoofers to be used. In this case, go
to step 10.
Surround
Back
Select the number of surround back speakers to be
used. In this case, go to step 11.
• “Surround Back” can be set when “Assign Mode” is
set to “Surround Back”.
9
Use
o
p
to select a front speaker, and then press
ENTER
.
A
Select this to use front speaker A.
B
Select this to use front speaker B.
A+B
Select this to use front speakers A and B simultaneously.
10
Use
o
p
to set whether or not a subwoofer channel is
measured, and then press
ENTER
.
Measure Set for measuring a subwoofer.
Skip
Set for no measuring of a subwoofer.
11
Use
o
p
to set whether or not a surround back
channel is measured, and then press
ENTER
.
Measure
(2spkrs) Set for measuring two surround back speakers.
Measure
(1spkr)
Set for measuring a surround back speaker.
Skip
Set for no measuring of a surround back speaker.
12
Press
o
or
BACK
.
step 5.
NOTE
After performing Audyssey® Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey® Setup again.
5
Use
o
p
to select the
configuration of the connected
speakers, and then press
ENTER
.
Surround Back Setting for 7.1-channel playback using surround
back speakers.
ZONE2
Setting to assign the unit’s built-in power amplifier
for ZONE2 and output the audio in stereo.
Bi-AMP
Setting to use the front speakers via the bi-amp
connection.
Front B
Setting to use the second set of front speakers for
playback.
Front Height
Setting for 7.1-channel playback using front height
speakers.
6
Press
o
or
BACK
to exit the “Amp Assign” setting.
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD