Marantz NR1604 - Manual (Page 28)

25
Calculation
Set up speakers (Audyssey® Setup)
11
Repeat step 10, measuring positions 3 to 6.
When measurement of position 6 is completed, a
“Measurements finished.” message is displayed.
Audyssey Setup
Repeat Last Test
Calculation
Measurements finished.
12
Select “Calculation” and then press ENTER .
Measuring results are analyzed, and the frequency response of
each speaker in the listening room is determined.
Audyssey Setup
Calibration completed! Now calculating...Please wait.
50%
• Analysis takes several minutes to complete. The more speakers
and measurement positions that there are, the more time it takes
to perform the analysis.
Measurement (2nd – 6th)
• In this step, you will perform measurements at multiple positions
(one to five additional positions) other than the main listening
position.
• Just one listening position can be measured if you so choose, but
measuring multiple positions increases the accuracy of the correction
of acoustic distortion within the listening area.
10
Move the Setup and
measurement microphone to
position 2, select “Continue”,
and then press ENTER .
The measurement of the second
position starts. Measurements can be
made in up to six positions.
Audyssey Setup
Cancel
Measuring the LEFT FRONT SPEAKER...
Audyssey Setup
Calculation
Back
Continue
Place the microphone at ear level at the 2nd listening position,
then select “Continue”...
• To skip measuring the second and subsequent listening position,
use i to select “Calculation” and press ENTER to proceed to step
13.
• To measure the second position again, use i to select “Repeat
Last Test” and press ENTER .
Basic instructions
Advanced instructions
Information
Basic instructions
v See overleaf
DVD