Marantz NR1604 - Manual (Page 96)

93
Connections (Advanced connection)
Connecting the REMOTE CONTROL connectors
Remotely connecting Marantz devices
n Performing operations by RC on this unit without visual contact
• You can connect an external IR receiver to the REMOTE CONTROL connectors to perform operations
on this unit with the supplied remote control unit without visual contact. This might be necessary if
the unit is hidden in a cupboard or corner, so you can't directly point with the remote control unit to
the device.
• To do this, disable the remote control signal receiving function ( vpage 100 “Remote lock function”).
RC OUT
IR receiver
NOTE
When not connecting an IR receiver,
make sure to enable the remote control
signal receiving function. When the
function is disabled, you can not perform
operations with the remote control unit.
n Remotely connecting Marantz devices
• When you are using a Marantz device other than this unit that supports remote connection, you can
transmit remote control signals just by connecting the device to the REMOTE CONTROL IN/ OUT
connector with a monaural cable.
• Set the remote control switch located on the rear panel of the connected audio component to
“EXTERNAL” or “EXT.” to use this feature.
Remotely control a Marantz Blu-ray player by the Marantz Remote App
Marantz Blu-ray disc player of newer generation also can be controlled via a network receiver unit using the
Marantz Remote App. Please ensure REMOTE CONTROL system of the receiver unit and the BD-Player
is set up as shown in the previous section.
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD