Orion System GPC-XP Controller - Manual (Page 20)

Section 6: Confi guring Relays
GPC-XP Controller Technical Guide 20
Relays
The Relays Window is located in the upper right of the GPC-XP
Controller Status Screen (Figure 8, page 11). There are 8 Relays.
See Figure 32 below for the Relays Window component summary
and the pages that follow for details.
Figure 32: Relays Window
Components and Navigation
Right or left-click on any of the Relay fi elds
to access the description entry box to add or
change the name of the Relay.
Left-click on this Status box to confi gure the
Relays.
Right-click to override the Relay.
The bell will light up to indicate that an alarm
is on.
The Light bulb will light up when the Input is in
the Occupied Mode.
Hi Limit Setpoint and Lo Limit Setpoint.
Amount of time in hours and minutes that the
relay has been energized.
Renaming Relays
To give the Relay a new name, click on the blue highlighted Relay
# fi eld and the Relay Data Entry Dialog Box will open (Figure 33
below). Once you have typed in a new description, press
<ENTER>
to save.
Figure 33: Relay Data Entry Dialog Box