Orion System GPC-XP Controller - Manual (Page 55)

GPC-XP Controller Technical Guide
Index
55
C
Calculation Interval..............30
Calibrate Sensor..............16
Cancel Override
Analog Output..............33
Carbon Dioxide Sensor
Communicating..............13
Changeover Interval..............27
Clear Sensor Override..............16
CommLink..............7
Baud Rate..............8
CommLink 5
Baud Rate..............8
CommLink IV..............7
CommLink Jumpers..............7
Communicating Carbon Dioxide Sensor..............13
Communicating Humidity Sensor..............13
Communicating Sensor Address..............13
Communicating Temperature Sensor..............13
Communication Settings..............7
Confi guring Alarms..............39
Confi guring Analog Inputs..............13
Confi guring Analog Outputs..............29
Confi guring Binary Inputs..............18
Confi guring Relays..............21
Controlling Schedule..............32
Relays..............24
,
25
Control Method Field..............22
Control Setpoints..............31
Control Setpoints Window..............31
Control Source..............31
Decreasing Proof Setpoint..............24
High Limit Setpoint..............24
Increasing Proof Setpoint..............24
Low Limit Setpoint..............24
Night Setback Setpoint Spread..............24
Control Source Field..............23
Control Source Setpoints..............24
Control Source Window..............31
Control Type
Floating Point Control..............30
PID Control..............30
Control Type Field..............29
Copying Schedules..............37
Copying Setpoints..............44
Copy Setpoints Window..............37
D
Decreasing Proof Setpoint..............24
Default Printer Selection..............46
Defaults
Resetting..............43
Delay & Run Times..............27
Derivative Constant..............30
Diagrams
GPC-XP Wiring..............6
Direct Acting Floating Point..............29
Direct Acting PID..............29
Disable Mode Offsets..............31
Disable Relay..............27
E
Enabling Alarms..............39
Enabling Binary Input..............32
Enabling Relay..............25
,
32
Ending Day..............43
Environmental Requirements..............5
Export Daily..............46
Export Monthly..............46
F
File Open Window..............44
File Save Window..............37
, 44
Floating Point Control..............30
Follow Active Binary Input..............22
Follow Inactive Binary Input..............22
Follow Relay..............18
Follow Relay Output..............22
Follow Schedule..............22
,
23
Formula
User Entered..............15
Formula Help..............49
C-F