Orion System GPC-XP Controller - Manual (Page 4)

Zone
Zone
Overview
GPC-XP Controller Technical Guide 4
Step-By-Step Guide
Step-By-Step Guide
This guide will lead you through each step in confi guring your GPC-
XP Controller. Below is a quick overview of each step.
Section 1: GPC-XP Wiring & Setup—This section explains
how to mount and wire your GPC-XP properly. It also explains how
to set the address and baud rate for your particular system.
Section 2: Prism 2 Installation—This section explains how
to install Prism 2 software required to program your GPC-XP Con-
troller. If you are not familiar with the Prism 2 software program,
please refer to the Prism 2 Technical Guide which can be downloaded
from the Orion Controls website: www.orioncontrols.com.
Section 3: GPC-XP Personalization & Status—This sec-
tion explains how to individualize and access GPC-XP Controllers
when more than one is installed and also provides and overview of
the GPC-XP Controller Status Screen.
Section 4: Confi guring Analog Inputs—This section ex-
plains how to confi gure analog inputs, individualize analog input
descriptions, and calibrate thermistor sensors, and override and clear
other analog input values.
Section 5: Confi guring Binary Inputs—This section ex-
plains how to confi gure binary inputs, individualize binary input
descriptions, and override binary inputs.
Section 6: Confi guring Relays—This section explains how
to confi gure relay outputs and individualize relay descriptions.
Section 7: Confi guring Analog Outputs—This section
explains how to confi gure analog outputs, individualize analog output
descriptions, override voltages, and cancel overrides.
Section 8: Outdoor Status and AVC (Analog Value
Comparison) Status—This section explains how to confi gure
and view AVC and Outdoor Status setpoints.
Section 9: Setting Schedules—This section describes how
to confi gure daily and holiday schedules and perform schedule force
modes.
Section 10: Confi guring Alarms—This section explains how
to confi gure and view alarms.
Section 11: Miscellaneous Settings—This section includes
miscellaneous settings for Week Schedule Broadcasts, AVC Inputs,
AVC Setpoints, Rouge Sensor Limits, Reset Rogue Sensor, Outdoor
Air Broadcasts, Trend Logging, and Daylight Savings.
Section 12: Saving and Copying Setpoints—This section
explains how to save GPC-XP setpoints to a fi le on your computer
and how to restore GPC-XP setpoints once you have saved them
to a fi le.
Section 13: Viewing and Printing Trend Logs—This
section explains how to view and print Trend Logs.
Appendix A—This appendix provides Help Screen information.
Appendix B—This appendix explains USB Driver Installation.
Index—The index provides page numbers for easy reference to
quickly fi nd the information you need.