Orion System PT-Link II LON - Manual (Page 3)

PT-Link II Interface 3
PT-Link II LON ® Technical Guide
The OE368-23-LON, PT-Link II LON, provides bi-directional communi-
cation between ONE* of the following types of Orion controllers—RNE,
VCB-X, VCM-X, SA, VCM, MUA II, or VAV/CAV:
RNE Controller (SS1045)
VCB-X Controller (SS1051)
VCM-X Controller (SS1026, SS1030, SS1032,
SS1033, SS1034, Y200920)
SA Controller (Y200921)
VCM Controller (SS1016, Y200409, Y200616, Y200822)
** MUA II Controller (Y200405); VAV/CAV Controller
(Y200301)
To determine what controller you have, you must look at the label located
on the controller EPROM. If the controller label does not match any of
the SS or Y numbers listed above, your controller will not work with
the PT-Link II LON
® .
*NOTE: The PT-Link II LON device can be used to connect to only
one Orion controller. If more than one Orion controller
is present in a system, each one will require a PT-Link
II LON device for integration with a LON protocol net-
work.
**NOTE: Documentation is available for MUA II/VAV/CAV on
our Orion Controls website: www.orioncontrols.com
Data Sharing
The PT-Link II LON interface provides the following data sharing
capabilities:
• Provides values from points on the Orion side of the
gateway to LON ® devices as if the values were
originating from LON ® objects.
•
Allows LON ® devices to modify point values on the
Orion controller side of the PT-Link II LON ® by using
standard LON ® write services.
Hardware Specifi cations
Table 1 contains the hardware specifi cations for the PT-Link II LON ®
interface.
Technical Data
LON® Loop TP/FT-10 (78 Kps)
Controller Loop RS-485, 9600 Baud Rate
Network Protocol LONWorks®
Protocol
(WattMaster Loop) HSI Open Protocol Token Passing
Power Input Voltage 24 VAC
Power Consumption 10 VA Maximum
Operating Temp -30°F to 150°F
Operating Humidity 90% RH Non-Condensing
Weight 4.7 oz.
Table 1: PT-Link II LON ® Interface Technical Data
System Requirements
• The PT-Link II LON ® interface is packaged and assembled
as surface mount. Surface mount components are included
for your convenience.
• Computer running Microsoft Windows TM operating
system.
• Ethernet Crossover Cable (supplied).
• PT-Link LON & RUINET software—included on
CD-ROM and also downloadable from www.orioncontrols.
com
General Information
Revised 10/11/12