Quintum Technologies Tenor Call Relay SP - Manual (Page 32)

3-2 P/N 480-0048-00-10
Chapter 3: Installation
Installation
Before you begin the actual installation, review the pre-installation guidelines which follow and inspect the
package contents.
Pre-Installation Guidelines
• Always use an anti-static wrist strap when handling cards.
• Only trained service technicians should remove the unit’s cards. Inside parts have hazardous voltages
and are extremely sensitive to static.
• Do not connect equipment in wet conditions and keep away from dusty areas.
• The area must not exceed the temperature and humidity guidelines outlined in Appendix A: Technical
Specifications.
• Avoid exposing the unit to excessive vibrations.
• Mechanical loading of rack should be considered so that the rack remains stable and unlikely to tip over.
Ensure no equipment is put on top of the unit.
Inspect Package Contents
Before you install the hardware, ensure the following components are included in your shipment:
• Call Relay SP and Mounting Hardware
• 1 AC Power Cable (for AC units only)
• DB-9 RS-232 Serial Cable (for connection to CPU card; grey if provided by Quintum)
• RJ-45 LAN Cable
• 1 ESD Wrist Strap
• #10 - 32 x 5/8 screws (qty: 4)
• #10 - 32 clip nuts (qty: 4)
• 6 mm x 20 mm screws (qty 4)
• 6 mm clip nuts (qty 4)
• Power Cord Strain Relief
• Product Guide in CD format
If a listed component is not included in your package, contact your customer service representative.
Install in Rack
Locate the Call Relay SP within the same area as your Ethernet hub; it is intended to be installed in a 19” rack.
Mounting brackets are attached to the unit; the rack is not included with your system. Included with the unit
are the screws and clip nuts listed below. The sizes should allow installation in most racks. If your rack does
not use the size screws listed in the table, please consult the instructions you received with the rack.
Required Materials
• 19” rack (not included with system)
• #10 - 32 x 5/8 screws (qty: 4) (included with system)