Quintum Technologies Tenor Call Relay SP - Manual (Page 78)

P/N 480-0048-00-10 7-12
Chapter 7: Call Detail Recording
Outgoing Slot: If the call is outgoing, this field identifies the slot the call is going out on. Valid entry: 1-13.
This field is not applicable and blank.
Outgoing Device. If the call is outgoing, this field identifies the Device the call is going out on. This field is
not applicable and blank.
Outgoing Digital Interface. If the call is outgoing, this field identifies which Digital Interface the call is
going out on. This field is not applicable and blank.
Outgoing Channel. If the call is outgoing, this field identifies which channel the call went out on. Valid entry:
1-31. This field is not applicable and blank.
Autoswitch Time: This is the date and time the autoswitched occurred (when the call is switched from VoIP
to circuit). The entry will be in the following format: yyyymmddhhmmss where yyyy (4 digits for year), mm
(2 digits for month), dd (2 digits for day), hh (2 digits for hour), mm (2 digits for minutes), ss (2 digits for sec-
onds). This field will be blank.
AutoSwitch Duration: The number of seconds that the autoswitch call was active. This field will be zero.
Bad IP Quality Events: The number of bad quality events that occur during a VoIP call. This number deter-
mines the overall quality of the call. This field will be zero.
Autoswitch Flag. The terminating side of the autoswitch call initially terminates to the internal autoswitch
agent before the call is actually autoswitched. This termination generates an extra CDR in addition to the orig-
inal call that is autoswitched. This field will be zero.
Calling Party Number. The number called from. The format will be delivered in whatever format the PSTN
or PBX delivers to the Call Relay SP.
PIN Code. PIN code entered. 14 digits maximum. This field will be blank.
Local Call ID #. Unique identification number, generated by the local-side. Call Relay SP, for call record
matching purposes. Generated only for IP calls.
Remote Call ID #. Unique identification number, generated by the remote-side Call Relay SP, for call record
matching purposes. Only generated for IP calls.
The following is a CDR field used in the extended format 4 and 104:
Incoming/Outgoing IP DN. If this is an incoming IP call, the number displayed will be the number as
received from the other endpoint. If this number is an Outgoing IP call, the number displayed will be the DN
as it was sent out over IP (Outgoing number plus prepended digits).