Quintum Technologies Tenor Call Relay SP User Manual
Page 42
3-12
P/N 480-0048-00-10
Chapter 3: Installation
14. Enter a login name. The default login name is admin.
15. Enter a password. The default password is admin. To change this password later, see Chapter 4: Configur-
ing Call Relay SP via CLI. Questions about the unit will scroll on the screen.
16. You will be asked to configure an Ethernet port. Enter Y to configure the Ethernet port.
Figure 3-10 Configure Ethernet port
NOTE:
If you are unsure of the following values, contact your network administrator.
17. For IP address, enter the IP address for the Call Relay SP unit.
18. For Subnet Mask prompt, enter the subnet mask. This address is used to differentiate the network portion
of the IP address from the host portion of the IP address.
19. For Default Gateway IP, choose whether there should be a default gateway (router) which routes packet
data outside of your LAN, and enter its IP address.
The Call Relay SP will automatically reboot with the new IP address.
Requests Ethernet
Address