Quintum Technologies Tenor Call Relay SP - Manual (Page 74)

7-8 P/N 480-0048-00-10
Chapter 7: Call Detail Recording
Incoming LEG IP Address: The IP address for the Call Relay SP unit originating the CDR. The entry will be
in the following format: xxx.xxx.xxx.xxx.
Outgoing LEG IP Address: The IP address for the remote destination Call Relay SP. This will be generated
only if the call is VoIP; if the call is circuit based, this field will be blank.
Origination Trunk ID: Identifies the origination trunk ID of the line that initiated the call. The trunk ID is
often configured with an account code. This field will be blank.
Call Type: The type of call. Valid entry: 1 = voice, 2 = fax, 3 = modem, 4 = data.
Call Number Type: The called numbering plan used for the call per Q.931. Possible common entries are as
follows: 1 = Public/E.164, 9 = Private.
Incoming Slot: The slot number to which a call enters. This field is not applicable and blank.
Incoming Device: If the call is incoming, this field identifies which Digital Interface the call came in on.This
field is not applicable and blank.
Incoming Digital Interface: If the call is incoming, this field identifies which Device interface the call came
in on. This field is not applicable and blank.
Incoming Channel: If the call is incoming, this field identifies which channel the call came in on. Valid entry:
1-31. This field is not applicable and blank.
Outgoing Slot: If the call is outgoing, this field identifies the slot the call is going out on. Valid entry: 1-13.
This field is not applicable and blank.
Outgoing Device. If the call is outgoing, this field identifies the Device the call is going out on. This field is
not applicable and blank.
Outgoing Digital Interface. If the call is outgoing, this field identifies which Digital Interface the call is
going out on. This field is not applicable and blank.
Outgoing Channel. If the call is outgoing, this field identifies which channel the call went out on. Valid entry:
1-31.This field is not applicable and blank.
Autoswitch Time: This is the date and time the autoswitched occurred (when the call is switched from VoIP
to circuit). The entry will be in the following format: yyyymmddhhmmss where yyyy (4 digits for year), mm
(2 digits for month), dd (2 digits for day), hh (2 digits for hour), mm (2 digits for minutes), ss (2 digits for sec-
onds). This field will be blank.
AutoSwitch Duration: The number of seconds that the autoswitch call was active. This field will be zero.
Bad IP Quality Events: The number of bad quality events that occur during a VoIP call. This number deter-
mines the overall quality of the call. This field will be zero.
Autoswitch Flag. The terminating side of the autoswitch call initially terminates to the internal autoswitch
agent before the call is actually autoswitched. This termination generates an extra CDR in addition to the orig-
inal call that is autoswitched. This field will be zero.
The following are CDR fields used in the extended format (1 or 101) only.