Move -> paste, Move -> insert, Move -> paste move -> insert – Teac 2488 User Manual
Page 52: 4 – recorder
4 – Recorder
52
TASCAM 2488
User’s Guide
MOVE -> PASTE
This function takes the section of a track or tracks
marked by the IN and OUT points, and moves it to
the chosen track or tracks, starting at the TO point.
After the operation, the selected section of the source
between the IN and OUT points is replaced by
silence.
This operation overwrites anything which is already
recorded at the destination. The destination is there-
fore the same length as it was before the operation.
You can change the following values:
Src. Trk
This sets the source track or tracks from
which the section is taken. Choose
1
through
24
to
select an individual track. Choose
1/2
,
3/4
,
5/6
, etc. to
select a pair of tracks. Choose
1-24
to select all tracks.
Dst. Trk
This sets the destination track or tracks to
which the selected section is moved. What you can
select here depends on what you have selected for the
source track. If you have selected a single track, you
can select tracks
1
through
24
here. If you have
selected a pair of tracks (for instance,
1/2
), you can
only select track pairs here. If you have selected all
tracks (
1-24
), then
1-24
is the only option available to
you here.
Press
YES
to perform the operation or
NO
to leave
this screen.
NOTE
You can also use the
SHIFT
+
INSERT
key combination
to enter this function easily.
MOVE -> INSERT
This function takes the section of a track or tracks
marked by the IN and OUT points, and moves it to
the chosen track or tracks, inserting it as new mate-
rial, starting at the TO point.
After the operation, the selected section of the source
between the IN and OUT points is replaced by
silence.
The insert operation adds the selected section as new
material to the destination. Nothing is overwritten on
the destination, as any material following the TO
point is moved to the end of the newly-inserted
section. The destination is therefore longer than it
was before the operation.
You can change the following values:
Src. Trk
This sets the source track or tracks from
which the section is taken. Choose
1
through
24
to
select an individual track. Choose
1/2
,
3/4
,
5/6
, etc. to
select a pair of tracks. Choose
1-24
to select all tracks.
Dst. Trk
This sets the destination track or tracks
into which the selected section is inserted. What you
can select here depends on what you have selected
for the source track. If you have selected a single
track, you can select tracks
1
through
24
here. If you
have selected a pair of tracks (for instance,
1/2
), you
can only select track pairs here. If you have selected
all tracks (
1-24
), then this is the only option available
to you here.
Press
YES
to perform the operation or
NO
to leave
this screen.
OUT
IN
TO
OUT
IN
TO
OUT
IN
TO
OUT
IN
TO