Verilink M1-3 (880-503136-001) Product Manual - Manual (Page 22)

Quick Set-Up
2-4 Verilink M1-3 User Manual
1. Select C from the M1-3 Main Menu.
The M1-3 Configuration Menu displays ( Figure 2-3 ).
NOTE: Configure the T3 port, then configure the T1 ports.
Figure 2-3 M1-3 Configuration Menu
DS3 Port
Configuration
To configure the T3 port, select option P. The DS3 Port
Configuration Menu displays (
Figure 2-4 ).
Figure 2-4 DS3 Port Configuration Menu
1. Line Type—Type “M” to set the line type. Select M1-3 because
the carrier is splitting the T3 into T1s within its backbone
network.
2. Line Coding—This option must use the default, Bipolar.
Unipolar is not supported and will prevent data transfer.
3. FEAC (far end control)—Type “C” disable FEAC.
4. Inband Control—This example uses the default Enable because
this ensures far-end control regardless of carrier routing.
NOTE: No further menu options are required for this example setup.
-- M1-3 CONFIGURATION MENU -- -- M1-3 CONFIGURATION MENU -- -- M1-3 CONFIGURATION MENU -- -- M1-3 CONFIGURATION MENU --
P) T3 port setup Tn) T1 port setup P) T3 port setup Tn) T1 port setup P) T3 port setup Tn) T1 port setup P) T3 port setup Tn) T1 port setup
O) timing options X) exit this menu
O) timing options X) exit this menu O) timing options X) exit this menu O) timing options X) exit this menu
-- M1-3 DS3 PORT CONFIGURATION MENU -- -- M1-3 DS3 PORT CONFIGURATION MENU -- -- M1-3 DS3 PORT CONFIGURATION MENU -- -- M1-3 DS3 PORT CONFIGURATION MENU --
M) line type M13 M) line type M13 M) line type M13 M) line type M13
H) coding type Bipolar
H) coding type Bipolar H) coding type Bipolar H) coding type Bipolar
R) performance control On
R) performance control On R) performance control On R) performance control On
C) FEAC Disabled
C) FEAC Disabled C) FEAC Disabled C) FEAC Disabled
I) inband control Enabled
I) inband control Enabled I) inband control Enabled I) inband control Enabled
B) line build out Normal Cable
B) line build out Normal Cable B) line build out Normal Cable B) line build out Normal Cable
E) equipment id
E) equipment id E) equipment id E) equipment id
L) location id
L) location id L) location id L) location id
F) frame id
F) frame id F) frame id F) frame id
U) unit id
U) unit id U) unit id U) unit id
A) facility id
A) facility id A) facility id A) facility id
P) port id
P) port id P) port id P) port id
G) test Signal id
G) test Signal id G) test Signal id G) test Signal id
X) exit this menu
X) exit this menu X) exit this menu X) exit this menu