Wavecom W61PC V7.5.0 - Manual (Page 316)

306  WAVECOM Data Formats WAVECOM Decoder W61PC/LAN Manual V7.5
 In Pad[0]: Timestamp format, how to show timestamp in classifier textview: 0=Timestamp off, 1=
show Timestamp in 'Local time', 2= show Timestamp in 'Universal Time Coordinated (UTC)'
Data
This ‘FileType’ uses the data structure described in chapter “ Data Structures ” on page 304 to store the da-
ta.
A data package in the .WDA file contains the data of one classified signal.
The signal data of a signal detected by the classifier is written to a single string. The following values are
written to the string:
 Signal: the signal name displayed in the GUI e.g. 'Signal 1'.
 Mode: the mode name, e.g. 'CW-MORSE'.
 Modulation: the modulation e.g. F1B.
 Center frequency: the center frequency value including the unit, e.g. '1846.5Hz'.
 Shift: the shift value including the unit, e.g. '926.4Hz'.
 Baudrate: the baud rate value including the label if available, e.g. '158.7Bd', otherwise 'unclassi-
fied'.
 Bandwidth: the bandwidth value including the unit, e.g. '922.7Hz'
 Confidence: the confidence value including the unit, e.g. '51%'.
 Mode: the mode value.
 Center: the center frequency value.
 Shift: the shift value.
 BaudrateA: the baudrateA value.
 BaudrateB: the baudrateB value.
 Bandwidth: the bandwidth value.
 Time stamp: the time when the signal was classified, number of seconds elapsed since midnight
(00:00:00), January 1, 1970, coordinated universal time.
NOTE: the values are written to the string in the same order as listed above!
If not stored with _UNICODE enabled, then the string contains normal 8-bit characters values, from type
char, otherwise the string contains 16-bit characters, from type wchar_t.
A char value occupies 1 Byte and a wchar_t value occupies 2 Bytes in the binary .WDA file.
ClassifierCodeCheck data
The ‘FileType’ is “CCC“.
Header data
This file type uses the ‘File Header’ described in chapter “ File Header ” on page 303.
The following additional data is stored in the Header:
 Pad[0]: Timestamp format, how to show timestamp in classifier textview: 0=Timestamp off, 1 =
show Timestamp in 'Local time', 2 = show Timestamp in 'Universal Time Coordinated (UTC)'
Data
This ‘FileType’ uses the data structure described in chapter “ Data Structures ” on page 304 to store the da-
ta.
A data package in the .WDA file contains the data of one classified signal or the CodeCheck data of a clas-
sified signal.
The data stored for the classier CodeCheck is divided into two parts, the Classifier part and the CodeCheck
part.
A .WDA file contains at first the classifier data and then the CodeCheck data.