Wavecom W61PC V7.5.0 - Manual (Page 54)

44  First start WAVECOM Decoder W61PC/LAN Manual V7.5
When a W61PC card is detected, the card selection dialog shows the type of product found, as well as the
hardware version and serial number.
In the example above, the W61PC software is looking for W61PC cards in a local computer. The process
should only take a few seconds.
Each device is identified by a unique serial number. Thus the application is able to search for devices au-
tomatically; this functionality is available for local as well as remote computers - pressing the Connect
button will start the process.
The selected entry is stored in the initialization file (*.INI file) for the card or device and no further entry
is necessary, when the application is restarted. The settings may be changed at any time.
The system can be used in a network configuration. This allows the system to be remotely controlled.
Font...
Clicking Font opens a configuration window.
Important: Please, note that changing the font and changing the alphabet are two different actions. If
you change the alphabet, then you select a table in a Unicode Font. If you change the font, then you
change the graphical representation (Arial, Courier etc.) of the characters of an alphabet. You may run in-
to problems if you select a non-Unicode font and change the alphabet.
For some types of transmission it will make sense to change the font - this depends on the software that
was used for the transmission.
Temp Files...
Clicking Temp Files opens a configuration window.
You can set the number of lines to be saved to temporary files during a session. These limits allow a user
to leave his computer on for days, while not exhausting hard drive space.