H3C Technologies H3C SR8800 - Manual (Page 101)

90
Perform the display interface tunnel command on Router A. You can find that the tunnel interface
is up.
[RouterA] display interface tunnel
Tunnel3 current state: UP
Line protocol current state: UP
Description: Tunnel3 Interface
The Maximum Transmit Unit is 1500
Internet Address is 6.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
0 packets input, 0 bytes
0 input error
0 packets output, 0 bytes
0 output error
Perform the display mpls te tunnel command on each router to verify information about the MPLS
TE tunnel.
[RouterA] display mpls te tunnel
LSP-Id Destination In/Out-If Name
1.1.1.1:1 3.3.3.3 -/GE3/1/1 Tunnel3
[RouterB] display mpls te tunnel
LSP-Id Destination In/Out-If Name
- - GE3/1/1/GE3/1/2 Tunnel3
[RouterC] display mpls te tunnel
LSP-Id Destination In/Out-If Name
- - GE3/1/1/- Tunnel3
Perform the display mpls lsp command or the display mpls static-cr-lsp command on each router to
verify information about the static CR-LSP.
[RouterA] display mpls lsp
-------------------------------------------------------------------
LSP Information: STATIC CRLSP
-------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
3.3.3.3/32 NULL/20 -/GE3/1/1
[RouterB] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP
------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
-/- 20/30 GE3/1/1/GE3/1/2
[RouterC] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP