H3C Technologies H3C SR8800 - Manual (Page 95)

84
Step Command Remarks
5. Enable periodic LSP tracert for
the MPLS TE tunnel.
mpls te periodic-tracert [ -a
source-ip | -exp exp-value | -h
ttl-value | -m wait-time | -t time-out
| -u retry-attempt ] *
By default, periodic LSP tracert is
disabled for MPLS TE tunnels.
6. Configure MPLS TE to tear
down a failed RSVP TE tunnel
and reestablish it.
mpls te failure-action teardown
Optional.
Not configured by default.
NOTE:
For more information about the mpls lspv command, see MPLS Command Reference.
Configuring protection switching
Configuration prerequisites
Before configuring protection switching, do the following:
• Configure MPLS basic capabilities
• Enable MPLS TE and create an MPLS TE tunnel
• Configure BFD for the MPLS TE tunnel.
Before configuring a protection tunnel, prepare the following data:
• Interface number of the main tunnel in the protection group
• ID of the protection tunnel in the protection group
Configuration procedure
To configure protection switching:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter tunnel interface
view.
interface tunnel tunnel-number N/A
3. Configure a protection
tunnel for the main
tunnel.
mpls te protection tunnel tunnel-id [ holdoff
holdoff-time | mode { non-revertive | revertive [ wtr
wtr-time ] } ] *
N/A
4. Configure an external
protection switching
action.
mpls te protect-switch { clear | force | lock | manual
{ protect-lsp | work-lsp } }
Optional.
By default, no switching
action is configured.
5. Commit the current
configuration of the
tunnel.
mpls te commit N/A
Displaying and maintaining MPLS TE