H3C Technologies H3C SR8800 - Manual (Page 378)

367
Configuring RIPng between MCE and PE
To configure RIPng between MCE and PE:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a RIPng process
for an IPv6 VPN
instance and enter
RIPng view.
ripng [ process-id ] vpn-instance
vpn-instance-name
Required
3. Redistribute the VPN
routes.
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | route-policy
route-policy-name ] *
By default, no route of any
other routing protocol is
redistributed into RIPng.
4. Configure the default
cost value for the
redistributed routes. default cost value
Optional
0 by default
5. Return to system view. quit N/A
6. Enter interface view. interface interface-type interface-number N/A
7. Enable the RIPng
process on the
interface.
ripng process-id enable Disabled by default.
NOTE:
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
Configuring OSPFv3 between MCE and PE
To configure OSPFv3 between MCE and PE:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create an OSPFv3 process for
an IPv6 VPN instance and
enter OSPFv3 view.
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
Required
3. Set the router ID. router-id router-id Required
4. Redistribute the VPN routes.
import-route protocol [ process-id
| allow-ibgp ] [ cost value |
route-policy route-policy-name |
type type ] *
By default, no route of any other
routing protocol is redistributed
into OSPFv3.
5. Configure a filtering policy to
filter the redistributed routes.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ bgp4+ | direct | isisv6
process-id | ospfv3 process-id |
ripng process-id | static ]
Optional
By default, redistributed routes are
not filtered.
6. Return to system view. quit N/A
7. Enter interface view.
interface interface-type
interface-number
N/A