H3C Technologies H3C Intelligent Management Center - Manual (Page 47)

40
Component Subcomponent Target server Remarks
VAN SDN Manager VAN SDN Manager
Master and
subordinate servers
N/A
Resource Automation
Manager Resource Automation
Manager Master and
subordinate servers
N/A
UC Health Manager UC Health Manager
Master and
subordinate servers
N/A
Endpoint Mobile
Office
Mobile Office Manager
Master and
subordinate servers
N/A
Mobile Office MDM Proxy
Master and
subordinate servers
N/A
Intelligent Strategy Proxy
Master and
subordinate servers
N/A
The installation and deployment procedures for the common service components are the same. The
following information describes how to install and deploy NTA, UAM, TAM, and MVM.
Table 9 lists the service components that use the same installation and deployment procedures as the
example components.
Table 9 Service components classified by deployment procedures
Example component
Component with the same
procedure
Remarks
NTA
APM, BIMS, IVM, SHM, SOM,
UBA, VSM, WSM, VFM, SDNM,
RAM, UCHM, QoSM, VCM,
iNode DC
No parameter is required to
complete the installation and
deployment.
UAM EMO
Additional parameters are required
to complete the installation and
deployment.
TAM EAD
Additional parameters are required
to complete the installation and
deployment.
MVM N/A
Additional parameters are required
to complete the installation and
deployment.
Before you deploy a service component, deploy the base IMC components and the components on
which the service component depend.
See "
Prerequisites for deploying IMC in distributed mode " before deploying service components in
distributed mode.
Installing and deploying NTA
NTA includes the following subcomponents:
• Network Traffic Analyzer and Network Behavior Analyzer, which can be deployed only on the
master server.