SMA SC 200 Installation - Manual (Page 52)

External Connections SMA Solar Technology AG
52 SC20_25_35-IEN094521 Installation Guide
6.1 Removing the Sliding Plates
The external cables are fed in via the base of the Sunny Central. To do so, sliding plates in the base
must be removed. The following diagram shows the position of the sliding plates in the DC- / inverter
cabinet and in the AC cabinet.
1. Remove the sliding plates (A) in the front area of the DC- / inverter cabinet and the AC cabinet.
2. Keep the sliding plates in a safe place. After completing the installation work, the sliding plates
must be reinstalled. (See section 6.11 ”Fitting the Sliding Plates” (page 72)).
NOTICE!
Soiling in the Sunny Central adversely affects operation.
• If no work is performed on the Sunny Central (e.g. at night), re-insert the sliding plates
to protect the Sunny Central against soiling.