Yaskawa V7 PROFIBUS-DP - Manual (Page 16)

Installation 1-10
‹ Verify V7 PROFIBUS-DP Option Operation
„ Apply power to the drive.
„ Verify that the diagnostic LEDs on the front of the V7 PROFIBUS-DP Option are in their correct state.
Table 1.4 – Correct Diagnostic LED States
LED Display
PWR COM ERR WD
Content Cause
Solid Green Solid Green OFF Flashing Green Normal Normal communication possible.
„ Remove power from the drive and wait for the charge lamp to be completely extinguished. Wait at least five additional minutes
for the drive to be completely discharged. Measure the DC bus voltage and verify that it is at a safe level.
„ Secure the communication option to the drive, aligning the recessed screw at the top-center of the option with the threaded hole
in the mounting bracket.
„ Install the operator keypad and terminal cover.
„ Set drive parameters n003, n004 and n035 to appropriate values.
Table 1.5 – Option Specific Parameter Settings
Addr Param Function Data +/- Limits - Description Default
0 Operator keypad
1 Terminal
2 Serial Communication
103h n003 Operation Method Selection
3 Option Card (PROFIBUS-DP Option)
1
0 Operator keypad Pot
1 Operator keypad
2 Voltage Reference (0-10v)
3 Current Reference (4-20 Ma)
4 Current Reference (0-20 Ma)
5 Pulse Train Reference
6 Serial Communication
7 Multi-Function Analog Input (0-10vdc)
8 Multi-Function Analog Input(4-20ma)
104h n004 Reference Selection
9 Option Card (PROFIBUS-DP Option)
2
0 0.01 Hz (< 100hz), 0.1hz (100 Hz >=100hz)
1 0.1%
2-39 Rpm
123h n035 Frequency Reference Unit Selection
40-3999 User Setting
0