Yaskawa V7 PROFIBUS-DP - Manual (Page 25)

Network Configuration 2-3
Configuration
Once the V7 PROFIBUS-DP Option has been installed and the drive parameters set appropriately, it is necessary to add the drive to the
PROFIBUS-DP network through the use of a configuration tool. This tool is usually supplied by the vendor that supplied the PROFIBUS-
DP Master controller. This section provides a general overview of how to select the appropriate drive configuration. The Siemens COM
PROFIBUS configuration tool is used in the examples. The examples and descriptions below assume familiarity with both PROFIBUS-DP
network and setting up a PROFIBUS-DP Master for the devices on that network.
The PROFIBUS-DP Communication Option can be configured as one of three possible I/O configurations, 16 word input/output, 6 word
input/output and 3 word I/Os, combined input/output, messages. The structure of each message is described in Chapter 3 – Network
Communications.
‹ Configure Master Device
„ Copy the GSD file from the CD that came with the V7 PROFIBUS-DP Option to the GSD sub-directory under the COM
PROFIBUS directory. The GSD file may also be downloaded from http://www.drives.com
„ Open COM PROFIBUS and configure the Master device. A Siemens 545-1104 is used in this example.
„ Select the DRIVES block from the list of available devices. The cursor should change to Move the cursor to below
the icon representing the Master device and press the left mouse button.
Figure 2.1 – Select Drive
‹ Select Drive Address
A list box will appear displaying the available addresses for the drive. Select an address for the drive and click on the OK button. The
address selected must match the address switch setting on the V7 PROFIBUS-DP Option for the drive selected. Refer to the engineering
documentation or network schematic to determine which address is applicable for the drive selected.
Figure 2.2 – Select Address