Sony ILCA-99M2 - Manual (Page 149)

Note
The light of the flash may be blocked if the lens hood is attached and the lower part of a recorded
image may be shaded. Remove the lens hood.
When using the flash, stand 1 m or more away from the subject.
You cannot use the flash when recording movies. (You can use an LED light when using a flash
(sold separately) with a LED light.)
Before attaching/removing an accessory such as a flash to/from the Multi Interface Shoe, turn off the
product first. When attaching an accessory, make sure that the accessory is fixed securely to the
product.
Do not use the Multi Interface Shoe with a commercially available flash that applies voltage of 250 V
or more or has the reverse polarity of the camera. Doing so may cause a malfunction.
You can use a flash of the reverse polarity with the Sync Terminal. Please use a flash with a sync
voltage of 400 V or less.
When shooting with the flash and the zoom is set to W, the shadow of the lens may appear on the
screen, depending on the shooting conditions. If this happens, shoot away from the subject or set the
zoom to T and shoot with the flash again.
The corners of a recorded image may be shaded, depending on the lens.
For details on compatible accessories for the Multi Interface Shoe, visit the Sony website, or consult
your Sony dealer or local authorized Sony service facility.
Shoot after you have turned on the flash and it is fully charged.
blinking: Charging is in progress
lit up: Charging is finished
The available flash modes depend on the shooting mode and function.
2