TA Triumph-Adler DC 2025 - Manual (Page 124)

CHAPTER 8 WHEN A PROBLEM OCCURS
8-4
1
Remove the misfed paper while taking care not to tear it.
* If the paper should be torn, remove all the scraps from
the inside the copier.
Close the drawer slowly.
* Check that the paper is kept under the claws of the
drawer. If not, reload the paper.
• Misfeed in left cover 1 (JAM 30 to 34, 36 to 52, 60, 61)
If the message below appears, a misfeed has occurred in the left
cover 1. Remove the misfed paper using the procedure given
below.
Pull up the lock lever to open the left cover 1.
2
3
1
(1) Cautions
WARNING
High voltage is present in the charger section. Take sufficient
care when working in this area, as there is a danger of elec-
trical shock.
CAUTION
The copier’s fixing unit is extremely hot. Take sufficient care
when working in theis area, as there is a danger of getting
burned.
• Do not reuse misfed paper.
• If paper is torn during removal, be sure to remove all loose scraps
from inside the copier, or they could cause misfeed later.
• After misfed paper has been removed, warm-up will begin. The
Misfeed indicator will turn off and the copier will return to the
same settings prior to the misfeed.
(2) Removal procedures
1 1 1 1 1 Misfeed in paper feed section
• Misfeed in drawer (JAM 10 to 13, 15 to 17)
If the message below appears, a misfeed has occurred in the
drawer (or optional paper feeder). Remove the misfed paper us-
ing the procedure given below.
Open the drawer.
Inch specifications
Metric specifications
Inch specifications
Metric specifications