TA Triumph-Adler DC 2025 - Manual (Page 28)

CHAPTER 4 BASIC OPERATION
4-4
9. At the end of copying
Finished copies are ejected onto the copy store section.
IMPORTANT
• Up to 250 sheets can be stored. Note that the number of sheets
that can be stored varies depending on the condition of the pa-
per used.
• If “Paper capacity exceeded. Remove paper from Inner.” appears,
the copy store section is full. Remove paper from the copy store
section and press the [Start] key to resume copying.
If “Paper capacity exceeded. Remove paper from Job sep.” ap-
pears, the optional job separator is full. Copying will automati-
cally resume when paper is removed from the job separator.
• If copied sheets are not stored tidily due to curls or other paper
conditions, remove the paper from the drawer or multi-bypass
used and turn the paper upside down.
CAUTION
If the copier will not be used for a short period of time (over-
night, etc.), turn the main switch OFF (
嘷 ). If it will not be
used for an extended period of time (vacations, etc.), remove
the power plug from the outlet for safety purposes during the
time the copier is not in use.
(1) Auto magnification selection mode
The original image is enlarged/reduced automatically according
to the paper size of the selected drawer.
IMPORTANT
• When using this mode regularly, select “AMS” in “Default mag-
nification” on page 6-28.
Set the original(s).
The size of the original will be automatically detected
and the same size paper as the original will be selected.
9
2. Enlargement/reduction
1
64% (70%) 5 1/2" ✕ 8 1/2" (A5)
8 1/2" ✕ 11" (A4)
11" ✕ 17" (A3)
129% (141%)
Metric specifications
Inch specifications
Metric specifications
Inch specifications