Tx/rx restriction, Select key set. (select key settings) – TA Triumph-Adler P-C3065 MFP User Manual
Page 145
8-8
Fax Settings > Default fax settings
TX/RX Restriction
This function allows you to send or receive originals only when communication requirements are met.
Transmission Restriction (page 8-10)
Select Key Set. (Select Key Settings)
If you register a function to the Left Select key or Right Select key, you can quickly set the function when using fax functions.
Rings(FAX/TEL)
If the reception method is FAX/TEL Auto Switch Reception, the number of rings until the
machine answers a call can be changed as needed.
Value
: 0 - 15
For Rings (FAX/TEL), this change is possible with some countries.
Forward Settings
Configure Forward Settings.
RX Settings
Select the reception mode.
Value:
Auto (Normal), Auto (FAX/TEL), Auto (Answering Machine), Manual, Auto (DRD)
If Auto (DRD) is selected, select the DRD Pattern.
Value
: Pattern 1 (Normal Ring), Pattern 2 (Double Ring), Pattern 3 (Short-Short-Long),
Pattern 4 (Short-Long-Short)
DRD reception mode is available for some countries.
DRD Reception (Available for some countries.) (page 5-29)
Remote SW Dial
To start fax reception by operation from the connected telephone set, use the following operation.
Value
: 00 - 99
Remote Switch Function (page 5-33)
Encryption RX
Turns on reception by encrypted communication.
Value
: Off, On
If turned on, select the encryption key.
ECM RX
Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International Telecommunication Union)
that retransmits data when an error occurs. Fax machines that have ECM mode check for
errors as they communicate, preventing distortion of the image due to noise on the line and
other conditions.
Value
: On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly longer than
when [Off] is selected.
RX Start Speed
Change the RX Start Speed.
When communication conditions are bad, the fax may not be received correctly. In that case,
set a lower RX Start Speed.
Value
: 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Item
Description
Left
You can register one of the following functions to each key.
Value
: None, Quiet Mode, Original Size, Original Image, FAX Resolution, Orig.Orientation,
Continuous Scan, File Name Entry, JobFinish Notice, FAX Delayed TX, FAX Direct TX, FAX RX
Polling, FAX TX Report, Density, Duplex
NOTE
[FAX TX Report] is displayed when [FAX TX Result] is set to [Specify Each Job].
Send Result Reports (page 7-4)
Right
Item
Description