TA Triumph-Adler P-C3065 MFP - Manual (Page 50)

3-19
Sending Faxes > Continuous Scan
Continuous Scan
Scan a large number of originals in separate batches and then produce as one job. Originals will be scanned
continuously until you select [End Scan].
FAX Direct Transmission
Scans all originals into memory, then dials and sends. Scanning of the originals starts after the connection is made with
the receiving system, allowing you to verify that each page of the fax has been properly sent.
Cancelling Direct Transmission
During direct transmission, to cancel communication during transmission, select the [Stop] key on the operation panel.
The originals that have been scanned are ejected, and the screen returns to the send default screen. When originals
remain in the document processor, take them out.
Setting for Direct transmission Description
On Starts direct transmission.
Dials the receiving system, and after the communication has started, originals are
scanned.
Off Starts memory transmission.
After originals are scanned into memory, the communication starts.
NOTE
In direct transmission, you can designate only one destination for one transmission.
For the procedure for transmitting FAX, refer to the following:
Basic transmission procedure (page 3-2)
The destination is dialed and communication starts before the original is scanned.
NOTE
In some cases, transmission may take place even if the [Stop] key.