Cx/px show attribute [attribute, Cx/px show driveinfo /c x – Avago Technologies 3ware SAS 9750-16i4e User Manual
Page 101
Port Object Commands
www.lsi.com/channel/products
93
/cx/px show attribute [attribute ...]
The /cx/px show attribute command shows the current setting of the given
attributes on the specified port or drive. You can request one or many
attributes. If you specify an invalid attribute, the loop terminates. Possible
attributes are: capacity, firmware, identify, lspeed, model, ncq, serial, smart
(SATA only), and status.
/cx/px show capacity
The /cx/px show capacity command shows the capacity of the drive attached
to the specified port in two formats: GB and blocks. Note that the CLI shows
capacity in GB that is computed based on division by 1000 (not 1024).
Example:
//localhost> /c0/p5 show capacity
149.05 GB (312581808 Blocks)
/cx/px show driveinfo
The /cx/px show driveinfo command shows the following information about
the drive for 9750 and 9690SA controllers:
Drive Type
can be either SAS or SATA.
Interface Type
can be either Direct or Enclosure. The Interface Type
indicates how the drive is connected to the controller.
Drive Ports
indicates the number of physical ports on the drive. SAS drives
are usually dual ported while SATA drives have only one port.
Drive Connections
indicates the number of connections from the controller
to the drive. There can be either one drive connection or two.
Additional information is available using the /cx/px show all command.
Example:
//localhost> /c3/p4 show driveinfo
/c3/p4 Drive Type = SAS
/c3/p4 Interface Type = Direct
/c3/p4 Drive Ports = 2
/c3/p4 Drive Connections = 1
/cx/px show firmware
The /cx/px show firmware command shows the firmware version of the drive
attached to the specified port.
Example:
//localhost> /c0/p5 show firmware
/c0/p5 Firmware Version = 65.13G65