Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 38)

Chapter 2. CLI Syntax Reference
30 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2
========================================================
Slot Day Hour Duration AdvVerify
--------------------------------------------------------
1 Sun 12:00am 24 hr(s) on
2 Mon 12:00am 24 hr(s) on
3 Wed 4:00pm 24 hr(s) on
4 Wed 12:00am 24 hr(s) on
5 Thu 12:00am 24 hr(s) on
6 Fri 12:00am 24 hr(s) on
7 Sat 12:00am 24 hr(s) on
/c3 basic verify weekly preferred start: Saturday, 12:00AM
For additional information about verify schedules, see “/cx add
verify=ddd:hh:duration” on page 60, “/cx set verify=basic [pref=ddd:hh]” on
page 66, and refer to the discussion of background tasks and schedules in
3ware SATA+SAS RAID Controller Card Software User Guide, Version 10.2.
update fw=filename_with_path [force]
The update fw command downloads the specified firmware image to the
controllers that are compatible with the firmware image and iterates through
all the controllers in the system, updating the firmware. For more information,
see “/cx update fw=filename_with_path [force]” on page 58.
Controller Object Commands
Controller object commands provide information and perform actions related
to a specific controller, such as /c0. For example, you use controller object
commands to view a list of alarms specific to a controller, to create schedules
for when background tasks are run, and to set policies for the controller. You
also use the controller object command /cx add type to create RAID arrays.
Syntax
/cx show
/cx show attribute [attribute ...] where attributes are:
achip|allunitstatus|autocarve|autorebuild|bios|
carvesize|ctlbus|dpmstat[type=inst|ra|ext]|driver|
drivestatus|firmware|memory|model|monitor|numdrives|
numports|numunits|pcb|pchip|serial|spinup|stagger|
unitstatus|
/cx show all (where all means attributes and configurations)
/cx show diag
/cx show alarms [reverse]
/cx show events [reverse]
/cx show AENS [reverse]
/cx show rebuild