Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 49)

Controller Object Commands
www.lsi.com/channel/products 41
/cx show pchip
The /cx show pchip command shows the PCI Interface Chip (PCHIP) version
of the specified controller /cx.
Example:
//localhost> /c0 show pchip
/c0 PCHIP Version = 1.x
/cx show serial
The /cx show serial command shows the serial number of the specified
controller /cx.
Example:
//localhost> /c0 show serial
/c0 Serial Number = F12705A3240009
/cx show spinup
The /cx show spinup command shows the number of concurrent SAS and
SATA disks that spin up when the system is powered up, after waiting for the
number of seconds specified with the
set stagger command. Spinup does
not work with SAS or SATA disks attached to an expander.
Example:
//localhost> /c0 show spinup
/c0 Disk Spinup Policy = 1
/cx show stagger
The /cx show stagger command shows the time delay between each group of
spinups at power up. Spinup does not work with SAS or SATA disks attached
to an expander.
Example :
//localhost> /c0 show stagger
/c0 Spinup Stagger Time Policy (sec) = 2
/cx show unitstatus
The /cx show unitstatus command presents a list of units currently managed
by the specified controller /cx, and shows their types, capacity, status, and unit
policies.
Possible statuses include: OK, VERIFYING, VERIFY-PAUSED,
INITIALIZING, INIT-PAUSED, REBUILDING, REBUILD-PAUSED,
DEGRADED, MIGRATING, MIGRATE-PAUSED, RECOVERY,
INOPERABLE, and UNKNOWN. (Definitions of the unit statuses are