PLANET WGSD-10020 - Manual (Page 202)

User’s Manual of WGSD-10020 Series
EType : The ACE will match Ethernet Type frames. Note that an Ethernet Type
based ACE will not get matched by IP and ARP frames.
ARP : The ACE will match ARP/RARP frames.
IPv4 : The ACE will match all IPv4 frames.
IPv4/ICMP : The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP : The ACE will match IPv4 frames with UDP protocol.
IPv4/TCP : The ACE will match IPv4 frames with TCP protocol.
IPv4/Other : The ACE will match IPv4 frames, which are not ICMP/UDP/TCP.
IPv6 : The ACE will match all IPv6 standard frames.
 Action Indicates the forwarding action of the ACE.
Permit : Frames matching the ACE may be forwarded and learned.
Deny : Frames matching the ACE are dropped.
 Rate Limiter Indicates the rate limiter number of the ACE. The allowed range is 1 to 16. When
Disabled is displayed, the rate limiter operation is disabled.
 Port Copy Indicates the port copy operation of the ACE. Frames matching the ACE are
copied to the port number. The allowed values are Disabled or a specific port
number. When Disabled is displayed, the port copy operation is disabled.
 CPU Forward packet that matched the specific ACE to CPU.
 CPU Once Forward first packet that matched the specific ACE to CPU.
 Counter The counter indicates the number of times the ACE was hit by a frame.
 Conflict Indicates the hardware status of the specific ACE. The specific ACE is not
applied to the hardware due to hardware limitations.
Buttons
: Select the ACL status from this drop down list.
Auto-refresh : Check this box to refresh the page automatically. Automatic refresh occurs at regular intervals.
: Click to refresh the page; any changes made locally will be undone.
4.10.2 Access Control List Configuration
This page shows the Access Control List (ACL), which is made up of the ACEs defined on this switch. Each row describes the
ACE that is defined. The maximum number of ACEs is 256 on each switch.
Click on the lowest plus sign to add a new ACE to the list. The reserved ACEs used for internal protocol, cannot be edited or
deleted, the order sequence cannot be changed and the priority is highest.
The Access Control List Configuration screen in Figure 4-10-2 appears.
202