PLANET WGSD-10020 - Manual (Page 80)

User’s Manual of WGSD-10020 Series

Engine ID Indicates the SNMPv3 engine ID. The string must contain an even number
between 10 and 64 hexadecimal digits, but all-zeros and all-'F's are not allowed.
Change of the Engine ID will clear all original local users.
Configure SNMP trap on this page. The SNMP Trap Configuration screen in Figure 4-3-2 appears.
Figure 4-3-2 SNMP Trap Configuration page screenshot
The page includes the following fields:
Object Description

Trap Mode
Indicates the SNMP trap mode operation. Possible modes are:
Enabled : Enable SNMP trap mode operation.
Disabled : Disable SNMP trap mode operation.

Trap Version Indicates the SNMP trap supported version. Possible versions are:
SNMP v1 : Set SNMP trap supported version 1.
SNMP v2c : Set SNMP trap supported version 2c.
SNMP v3 : Set SNMP trap supported version 3.

Trap Community Indicates the community access string when send SNMP trap packet. The
allowed string length is 0 to 255, and the allowed content is the ASCII characters
from 33 to 126.

Trap Destination
Address
Indicates the SNMP trap destination address.
 Trap Destination IPv6
Address
Provide the trap destination IPv6 address of this switch. IPv6 address is in
128-bit records represented as eight fields of up to four hexadecimal digits with a
colon separates each field (:). For example, 'fe80::215:c5ff:fe03:4dc7'. The
symbol '::' is a special syntax that can be used as a shorthand way of
80