Document Outline

• Start Here
  • System Requirements
  • Package Contents
  • Install ProSoft Configuration Builder Software
• To install ProSoft Configuration Builder from the ProSoft Web Site
• To install ProSoft Configuration Builder from the Product CD
  • Setting Jumpers
  • Install the Module in the Rack
  • Connect your PC to the Processor
  • Download the Sample Program to the Processor
    • Configuring RSLinx
• If RSLogix is unable to establish communication with the processor, follow these steps:
  • Connect your PC to the Module
• Configuring the MVI69-101S Module
  • ProSoft Configuration Builder
    • Set Up the Project
      • Adding a Project
• To add a project to an existing project file:
  • Adding a Module
• To add a module to your project:
• To add a module to a different location:
  • Set Module Parameters
• To rename an object:
  • Module Entries
• To configure module parameters
  • Comment Entries
• To add comments to your configuration file:
  • Printing a Configuration File
• To print a configuration file:
  • [Backplane Configuration]
    • Module Name
    • Read Register Start
    • Read Register Count
    • Write Register Start
    • Read Register Count
    • Failure Flag Count
    • Error Offset
    • Block Transfer Size
  • [IEC-870-5-101 Port 0]
    • Enabled
    • Time DB Offset
    • Data Link address
    • Data Link address Length
    • Common address of ASDU
    • Common address of ASDU Len
    • Inform. Object address Len
    • Select/Operate Timeout
    • Cyclic Data Transmission
    • Use ACTTERM with Setpoint
    • Use ACTTERM with Step
    • Single Char ACK F0, 1 or 3
    • Single Char ACK C1 or C2
    • Maximum ASDU Resp Len
    • Cause of Trans Octets
    • Freeze Start Type
    • Interval for Freeze
    • Set Priority Queues
    • Cyclic Set IV Time
    • IV Check Delay Time
    • IV Fail Count
    • Event Scan Delay
    • Scan Events
    • Time Type
    • Use Balanced Mode
    • Retry Count
    • Response Timeout
    • Baud Rate
    • Parity
    • RTS On
    • RTS Off
    • Minimum Delay
    • Receive Timeout
    • Backup Port Enabled
    • Backup Port Baud Rate
    • Backup Port Parity
    • Backup Port RTS On
    • Backup Port RTS Off
    • Backup Port Min Delay
    • Backup Port Handshaking
  • [IEC-870-5-101 Database]
    • Short Pulse Time
    • Long Pulse Time
    • Point Count
    • Sequence Flag
    • Parameter Offset
  • [M_SP_NA_1]
  • [M_DP_NA_1]
  • [M_ST_NA_1]
  • [M_ME_NA_1]
  • [M_ME_NB_1]
  • [M_ME_NC_1]
  • [M_IT_NA_1]
  • [C_SC_NA_1]
  • [C_DC_NA_1]
  • [C_RC_NA_1]
  • [C_SE_NA_1]
  • [C_SE_NB_1]
  • [C_SE_NC_1]
  • Download the Project to the Module
• To Download the Project File
• Ladder Logic
  • Module Data Object: MVI69101S_ModuleDef
    • User Data Objects - MV69101S_DATA
    • MVI69101S_CONTROL
      • MVI69101S_EventBlock
      • MVI69101S_Event
      • MVI69101S_Clock
    • Module Status Object: MVI69101S_STATUS
    • Block Control Data - MVI69101S_UTIL
  • Adding the Module to an Existing CompactLogix Project
  • Adding the Module to an Existing MicroLogix Project
• Diagnostics and Troubleshooting
  • Reading Status Data from the Module
    • Required Hardware
    • The Configuration/Debug Menu
      • Using the Diagnostic Window in ProSoft Configuration Builder
      • Navigation
        • Keystrokes
    • Main Menu
      • Viewing Block Transfer Statistics
      • Opening the Data Analyzer Menu
      • Viewing Module Configuration
      • Opening the Database Menu
      • Viewing Error and Status Data
      • Viewing Port Configuration
      • Receiving the Configuration File
      • Sending the Configuration File
      • Viewing Version Information
      • Warm Booting the Module
      • Viewing Data Type Setup
      • Viewing IEC 60870 Database Configuration
      • Exiting the Program
    • Database View Menu
      • Viewing Register Pages
      • Displaying the Current Page of Registers Again
      • Moving Back Through 5 Pages of Registers
      • Viewing the Previous 100 Registers of Data
      • Skipping 500 Registers of Data
      • Viewing the Next 100 Registers of Data
      • Viewing Data in Decimal Format
      • Viewing Data in Hexadecimal Format
      • Viewing Data in Floating Point Format
      • Viewing Data in ASCII (Text) Format
      • Returning to the Main Menu
    • Data Analyzer
      • Analyzing Data for the first application port
      • Analyzing Data for the second application port
      • Displaying Timing Marks in the Data Analyzer
      • Removing Timing Marks in the Data Analyzer
      • Viewing Data in Hexadecimal Format
      • Viewing Data in ASCII (Text) Format
      • Starting the Data Analyzer
      • Stopping the Data Analyzer
      • Returning to the Main Menu
    • Data Analyzer Tips
  • LED Status Indicators
    • Clearing a Fault Condition
    • Troubleshooting
• Reference
  • Product Specifications
    • General Specifications
    • Hardware Specifications
    • Functional Specifications
  • Functional Overview
    • General Concepts
      • Main Logic Loop
      • CompactLogix or MicroLogix Processor Not in Run
      • Backplane Data Transfer
    • Normal Data Transfer
      • Read Block
      • Write Block
      • How Data is Transferred
    • Status Block
    • Sending Events
    • Command Control Blocks
      • Introduction
        • Request Output Data from Processor
        • Event Message Block (Block 9958)
        • Get Module Time (Block 9970)
          • Block Format for Write
          • Block Format for Read
        • Set Module Time (Block 9971)
          • Block Format for Write
      • Warm Boot
      • Cold Boot
    • Data Flow Between MVI69-101S Module and CompactLogix or MicroLogix Processor
      • Slave Driver
    • Databases
  • IEC-60870-5-101 Protocol Implementation
    • General Parameter Configuration
      • Communication Parameters
      • Data Link Configuration
      • ASDU Configuration
• Example - Changing the ASDU Length:
  • Module Initialization
    • Unbalanced mode
      • Balanced Mode
    • Monitor Direction and Control Direction
    • Using Monitor Points
      • Monitor Data Transfer
• Example - Periodic Monitor Polling:
• Example - General Interrogation
• Example - Mode A
• Example I - Freeze Start Type
• Example II - Freeze Start Type
  • Monitor Points Addressing
    • M_SP_NA and M_DP_NA
    • M_ST_NA
    • M_ME_NA and M_ME_NB
    • M_ME_NC and M_IT_NA
    • Using Control (Command) Points
• Example - Monitor Point Configuration for Command Points:
  • Control Data Transfer
  • Command Points Addressing
    • C_SC_NA and C_DC_NA
    • C_RC_NA
    • C_SE_NA and C_SE_NB
    • C_SE_NC
    • Events
      • Deadbands
• Example - Parameter Data for Monitored Points:
  • M_ME_NA
  • M_ME_NB
    • Controlling the Generation of Events
      • General (All Points)
        • Data Type Level
        • Point Level
      • Time Information
      • Event Priority
• Example - Event Priority
  • Cable Connections
    • RS-232 Configuration/Debug Port
      • Disabling the RSLinx Driver for the Com Port on the PC
    • RS-232
      • RS-232: Modem Connection
      • RS-232: Null Modem Connection (Hardware Handshaking)
      • RS-232: Null Modem Connection (No Hardware Handshaking)
    • RS-422
    • RS-485
      • RS-485 and RS-422 Tip
    • DB9 to RJ45 Adaptor (Cable 14)
  • MVI69-101S Status Data Definition
  • MVI69-101S Database Design Forms
  • MVI69-101S Error Status Table
  • IEC 60870-5-101 Slave Interoperability Document
• Support, Service & Warranty
  • How to Contact Us: Technical Support
  • Return Material Authorization (RMA) Policies and Conditions
    • All Product Returns:
    • Procedures for Return of Units Under Warranty:
    • Procedures for Return of Units Out of Warranty:
    • Purchasing Warranty Extension:
  • LIMITED WARRANTY
    • What Is Covered By This Warranty
    • What Is Not Covered By This Warranty
    • Disclaimer Regarding High Risk Activities
    • Intellectual Property Indemnity
    • Disclaimer of all Other Warranties
    • Limitation of Remedies **
    • Time Limit for Bringing Suit
    • No Other Warranties
    • Allocation of Risks
    • Controlling Law and Severability
• Index