Canon imagePROGRAF GP-300 - Manual (Page 103)

6. Check the length of the roll paper and tap OK . 6.
Note
• The length of the roll paper to be displayed can be set in Roll length (change default) . •
Setting the Default Value of the Amount of Roll Paper Left when Managing by the Barcode
• If the length of the roll paper to be displayed is different from the length of the roll paper actually
used, set the actual length.
7. Select the timing when the warning message appears. 7.
Setting the Default Value of the Amount of Roll Paper Left when Managing by the
Barcode
When you select Barcodes in Manage remaining roll amount and if you feed roll paper on which no
barcode is printed, such as new roll paper, the screen to enter the roll paper length (remaining amount)
appears.
In this screen, the length (remaining amount) of default value appears. If the length is not correct, tap the
screen and enter a correct length.
When you want to change the length (remaining amount) of default value, follow the steps below.
1. Tap paper settings display area on Home screen of operation panel. 1.
Note
• If the Home screen does not appear, press the HOME button. •
2. Tap Paper settings . 2.
3. Tap Advanced . 3.
4. Tap Roll length (change default) . 4.
5. Specify the length of the roll paper and tap OK . 5.
103