Loading sheets in the printer – Canon imagePROGRAF GP-300 User Manual
Page 120
Loading Sheets in the Printer
Follow these steps to load sheets in the printer.
Important
• One sheet of paper can be loaded in the feed slot at a time. Do not load more than one sheet at a time.
•
This may cause paper jams.
• Before feeding paper or printing, make sure the sheet is flat against the roll paper cover. The sheet may
•
jam if it curls before feeding or printing and the trailing edge drops toward the front.
• Paper that is wrinkled or warped may jam. If necessary, straighten the paper and reload it.
•
• Load the paper straight. Loading paper askew will cause an error. (See "
•
Note
• Before loading cut sheets, check whether or not the inside of the top cover or the output guide is
•
soiled. If these areas are dirty, we recommend cleaning them in advance. (See "
.").
• Store unused paper in the original package, away from high temperature, humidity, and direct sunlight.
•
1.
Select sheets as the paper source.
1.
•
If a print job was received
•
Sheets are automatically selected, and the media type and size specified by the print job are
shown on the operation panel.
Tap
OK
and
Load paper
.
•
If no print job was received
•
1. Tap
Load paper
or
Replace paper
.
1.
2. Tap
Load cut sheet
or
Replace cut sheet
.
2.
Note
• If the Home screen does not appear, press the
HOME
button.
•
Note
• If any paper has been advanced that will not be used, a message is shown requesting you to
•
remove it.
120